Methods for setting the flash are explained in the following sections.
Setting the Flash to Fire for Each Shot (On)
When the [Flash] is set to [Auto], the flash does not fire if the surroundings are light. However, when shooting a backlit subject, the flash can be used to prevent the subject’s face from being obscured by shadows.
The procedure for setting the flash to fire for every shot is explained below.
Caution
[Hybrid Auto] (), [Auto] (
), [Creative Shot] (
), [Star Nightscape] (
), [Star Trails] (
), [Star Time-Lapse Movie] (
), [Fireworks] (
), [High Dynamic Range] (
), [Background Defocus] (
), [Movie] (
), [Manual] (
), [iFrame Movie] (
), [Short Clip] (
)
1. Press the power button to turn the camera on.
2. Move the [Flash pop up] () switch to raise the flash.
3. Press the ⋖⋗ button to display the setting screen, and then touch the icon on the bottom left of the screen.
Caution
4. Touch the [ ] icon.
5. When the icon displayed on the screen changes to [ ], the setting is complete.
Caution
The following four flash modes can be set.
For more information about each of the individual modes, please refer to the camera’s instruction manual.
[Auto: ]
[On: ]
[Slow Synchro: ]
[Off: ]
[Raise the flash] is displayed
When shooting in [AUTO] mode or [Hybrid Auto] mode in low-light conditions, [Raise the flash] may be displayed on the camera’s screen. In this case, please move the ⋖⋗ switch to raise the flash. As there is no automatic function to raise the flash, the flash will not fire unless it is raised manually.
When the message shown above is displayed, please move the ⋖⋗ switch to raise the flash as shown in the image below.
Flash Range
If your shots are dark despite the flash firing, move closer to the subject.
For details on the flash range, please refer to the table below.
Maximum wide angle ( | 50 cm - 6.0 m (1.6 - 20 ft.) |
Maximum telephoto ( | 50 cm - 2.4 m (1.6 - 7.9 ft.) |